Washing Machine Not Draining Water? 5 Easy Fixes for Front Load & Top Load Washers
Is your washer stuck with dirty water and refusing to spin? Follow our DIY checklist to clear coins, lint, and debris from the drain pump filter.
1. Clean the Coin & Lint Trap Filter (Front Load)
Over 80% of drainage problems occur because stray coins, hairpins, safety pins, and lint accumulate in the coin trap before the drain impeller.
Place a shallow tray and towel on the floor, open the bottom access flap, pull out the emergency drain hose to drain standing water, and unscrew the circular filter counter-clockwise. Wash thoroughly and check inside the chamber for foreign objects.
2. Check for a Kinked or Clogged Drain Hose
Inspect the ribbed plastic hose behind the washing machine. If the washer was pushed back against the wall, the hose may be pinched shut, preventing water evacuation. Also ensure the hose is elevated to the manufacturer recommended height (usually 60-90 cm) to prevent siphoning.
3. Inspect the Drain Impeller for Obstructions
With the filter removed, use a torch to look inside the housing. Use your finger or a pen to spin the plastic impeller vanes. If the impeller is jammed by a thread or hard coin, the motor will hum loudly and trip out on heat overload.
4. Faulty Drain Pump Motor
If the filter and hoses are completely clear but the machine still will not drain, the electrical windings or plastic gears of the drain pump motor may be worn out. Our doorstep technicians can replace the pump assembly in under 45 minutes.
About the author
Bharat Services Technical Team Bharat Services technicians who repair air conditioners and washing machines at customers’ homes. They write the troubleshooting and fault-diagnosis guides on this site from doorstep repair work across India.
Bharat Services is an independent doorstep repair company based in Pune, Maharashtra. Read about our service standards and warranty.
Frequently Asked Questions
Where is the drain filter located on a front load washing machine?
On most front load washers (Bosch, IFB, LG, Samsung), the drain filter is located behind a small access door at the bottom-right or bottom-left corner of the front panel.
Why does my washer display OE, 5E, or E20 error codes?
These are drain timeout error codes indicating that the machine failed to evacuate wash water within 5 to 10 minutes due to a clogged filter or faulty drain pump.
Explore Related Services & City Guides
More Repair Guides
Need this fixed at home?
Same-day and next-day doorstep slots across 87 cities. Written estimate before work starts.
₹199 diagnostic visit, credited against your repair bill if you go ahead.